Hardware Setup
11
FSB
SDRAM Type
SDRAM Type
Max Memory
66
FSB+33
10ns or faster
1GB
100
FSB
10ns or faster
FSB+33
7.5ns or faster
133
FSB-33
10ns or faster
FSB
7.5ns or faster
Front Panel Audio Connector (CN22)
This connector give you the option of a front panel audio jack
cable ext. to be plug into a special custom designed system case.
CPU/System Cooling Fan Connectors (FAN1/FAN2)
The board's management extension hardware is able to detect
the CPU and system fan speed in rpm (revolutions per minute).
These connectors supports 3-pin cooling fans with minimum
of 4000 RPM. The wiring and plug may vary depending on the
manufacturer. On standard fans, the red is positive (+12V), the
black is ground, and the yellow wire is the rotation signal.
IR Connector (IR1)
Select a UART Mode in BIOS's Integrated Peripherals menu the
UART port to support IR/CIR functions. (See section 3-4)
2-4 Main Memory Configuration
The DRAM memory system consists two banks and the memory size ranges from
32MBytes~1GBytes
. If you only use one bank it does not matter which one you use
and if you use two or more banks, it does not matter which bank you install first.
DRAM Specifications
DIMM type: 3.3V, 64/72-bit Synchronous DRAM
Module size: Single/double-sided 32/64/128/256/
512MBytes/1GBytes
DRAM speed: 7.5/10ns for Synchronous DRAM
Parity: Either parity or non-parity
This mainboard supports 3.3v, unbuffered, 4-clock, SDRAM DIMM only.
Buffered, 5V, or 2-clock SDRAM DIMMs should not be used.
Due to loading anomalies, using DIMM with an 'n x 4' DRAM base on this
mainboard is not recommended. For example, a DIMM that uses sixteen
16Mb x 4 devices should not be used.
