C
GS TGC Installation, Operation & Maintenance
C
GS TGC v2 220322
7
Basic Operation
Isolate the equipment from all hazardous live power sources before opening the cover!
When power is supplied to the TGC controller, the LED on the log of the cover will illuminate Red. To turn
the TGC controller off, disconnect electrical power supply.
The Status LED changes colour when the controller enters three (3) different states as follows.
Green.
Remains illuminated when gas is being supplied.
Yellow.
The controller LED will turn yellow ten (10) minutes before the automatic gas shut off
timeout is reached and when five (5) minutes remain the buzzer will beep, and the yellow LED will
then intermittently flash. After this time, the gas will automatically shut off until reactivated.
Red.
Remains illuminated when a remote emergency stop device has been activated.
The gas supply is isolated until the emergency has been investigated, rectified, and reset. Press
ON to re-enable/open the gas supply.
Basic Maintenance
Keep your gas controller in good working order - follow these basic principles.
✓
Remove any dust/debris from the outer enclosure regularly using a slightly damp cloth.
✓
Never use detergents or solvents to clean your device.
✓
Never spray air fresheners, hair spray, paint or other aerosols near the device.
✓
Never paint the device.
