-4 4-
[Replacement of Brake Disc and Brake pad]
WARNING
1
.
When the limit wear thickness of the brake disc reaches 3
mm
,
it
is
necessary
to
replace
it
;
2
.
When the limit wear thickness of the brake pad
reaches
1.5mm
,
it
is
necessary
to
replace
it
;
3
.
When
repalcing
the
brake
disc
:
it needs to take out the brake caliper, front wheel and dismantle the
connecting nuts with the front wheel before replacement
;
4
.
When
repalcing
the
brake
pad
:
Dismantle the brake caliper and loosen the
external brake pad spring on
the brake caliper before replacement
;
5. Do not drive the motorcycle immediately after replacement of new brake disc or brake pad
;
it
is
necessary
to
control
(
grasp and release
)
several times of front brake lever
until
the
brake
disc and the brake caliper
are well engaged.
[Front Brake Light Switch]
1. The front brake switch is installed at the connection between the front brake lever and the
④
brake pump.
2.
When grasping the front brake lever
,
the
front
brake
is
switched
on
and
the
brake light
is
on
;
when
releasing
the
front
brake
lever
,
the
brake
light
is
off
.
3.
Replace the switch when it is damaged.
1. Add: DOT3 or DOT4 non-petroleum base brake fluid; do not mix use products with
different brands;
2. The brake fluid is highly corrosive. Do not splash it to the surface of the painted or plastic
parts;if it is swallowed by accident, force him or her to spit it out;if it touches the eye or
skin, flush it with large amount of water and seek medical advice;
3. The hydraulic disc brake works under high pressure. To ensure safety and reliability, the
replacement time of the brake pad and the brake fluid shall not exceed the maintenance
intervals;
4. When the hydraulic disc brake system needs to be repaired, it can only be repaired by the
staff of “CFMOTO Service Station or authorized local dealer”.