Cetetherm Mini Plus CM737
Installation, service and operating instruction
18
8.6.5
Modifying the heating program
To change the heating program:
a) Press either of the
PROGRAM
or
buttons to enter the
programming mode.
The time /temperature settings for period
on Monday day 1 will
be flashing. The active period is highlighted by a flashing square
around the numbers at the bottom of the screen and the selected
day is shown with the day indicator.
b) To adjust the period, start time use the
or
buttons, the ‘OK?’ indicator will be displayed to
confirm the change. Holding the button down will change the time quickly.
Note:
If you are pressing the
or
buttons and the display flashes the next period, it means the
next period will be pushed forward.
c) Once the required time is reached press the green
button to confirm.
Note:
If the original time setting did not require adjustment press the green
button to move to
step
‘
d
’.
d) The temperature setting for period
on Monday (Day 1) will now be flashing. To adjust this, press the
or
buttons and confirm the setting again by pressing the green
button.
e) The next time and temperature period will now be active. Adjust this by repeating steps b - d above
until all four periods are set or press the
AUTO
button to run the program as set, at any time.
Chose how to set the program for the next day:
f) Press the
COPY DAY
button to copy Monday’s program into Tuesday. The display will go blank apart
from the ‘non-flashing’ day indicator, which indicates the day copied and the ‘flashing’ target day to
copy the program to. To accept this day, press the green
button. To select a different target day
press the
DAY
button until the ‘flashing’ day indicator is under the required day, and then accept it by
pressing the green
button.
Note:
Once the target day is confirmed it becomes the day that is copied if the
COPY DAY
button is
pressed again.
Or
Press the
DAY
button to move the day indicator to Tuesday (Day 2). The program for that day can then
be adjusted by following steps
b
to
e
. Programs for the remaining days can be set in the same way,
using the
DAY
button to move to the next day.
To exit the programming mode, select the desired operating mode by pressing the
AUTO
,
MAN
or
OFF
buttons.
Note:
To run the adjusted program; select the
AUTO
mode.
