Cessna 182T 2001, Pilot Operating Handbook

Page: 88 / 254

SECTION 4 - NORMAL PROCEDURES CESSNA
FAA APPROVED MODEL 182T
NOTE
When Master Switch is turned ON, some annunciators will
flash for approximately 10 seconds before illuminating
steadily. When panel TST switch is toggled up and held in
position, all remaining lights will flash until the switch is
released.
16. Fuel Selector Valve -- BOTH.
17. Flaps -- EXTEND.
18. Pitot Heat -- ON. (Carefully check that pitot tube is warm to the
touch within 30 seconds.)
19. Stall Warning -- CHECK. (To check the system, place the
vane upward; a sound from the warning horn with the Master
Switch on will confirm system operation.)
20. Pitot Heat -- OFF.
21. Master Switch -- OFF.
22. Trim Controls -- Neutral.
23. Baggage Door -- CHECK, lock with key.
2 EMPENNAGE
1. Rudder Gust Lock (if installed) -- REMOVE.
2. Tail Tie-Down -- DISCONNECT.
3. Control Surfaces -- CHECK freedom of movement and
security.
4. Trim Tab -- CHECK security.
5. Antennas -- CHECK for security of attachment and general
condition.
3 RIGHT WING Trailing Edge
1. Aileron -- CHECK freedom of movement and security.
2. Flap -- CHECK for security and condition.
4 RIGHT WING
1. Wing Tie-Down -- DISCONNECT.
2. Fuel Tank Vent Opening -- CHECK for blockage.
3. Main Wheel Tire -- CHECK for proper inflation and general
condition (weather checks, tread depth and wear, etc...).
4-8 Feb 23/01