m
aI
nt
Enan
CE
model no. 060-3742-2 | contact us 1-844-428-7277
38
lUbrICatIon
lubricate the linkage every 10 hours of use and
before long-term storage. Use 0W-30 oil.
no parts inside the gearbox are to be lubricated.
all bearings and bushings are permanently
lubricated and require no maintenance.
lubricating these parts will only result in the
grease getting on to the friction wheel and disc
drive plate, which could damage the rubber clad
friction wheel.
lonG-tErm StoraGE
never store the machine with gasoline in
the fuel tank in a confined area with bad
ventilation. Gasoline fumes could reach open
flames, sparks and cigarettes etc.
to avoid the engine freezing and problems
starting the engine, leave the engine running
for 5-10 minutes after your work has been
completed. this will ensure all moisture will
disappear that would otherwise cause starting
problems.
If the machine is to be stored for a longer period
than 30 days, the following procedures are
recommended.
1. Start the engine and let it run until it stops
due to lack of fuel.
2. Change the engine oil if it has not been
done for 3 months.
3. remove the spark plug and empty a little
engine oil (about 1 oz {30 ml}) in the hole.
Crank the engine a couple of times. replace
the spark plug.
4. Clean the whole machine thoroughly.
5. lubricate all the parts as stated in
lUbrICatIon section above.
6. Inspect the machine for damage, and repair
if necessary.
7. touch up any paint damage.
8. apply rust protection to the metal
surfaces.
9. Store the machine indoors if possible.
tranSPortInG
If the engine has been running, allow it to
cool for at least 15 minutes before loading the
machine on the transport vehicle. a hot engine
and exhaust system can burn you and can ignite
some materials.
Keep the engine level when transporting to
reduce the possibility of fuel leakage. move the
fuel valve lever to the off position.
