31
m
aI
nt
Enan
CE
5. remove the base frame cover (1) from the
underside of the snowblower by removing
the six m6 × 16 screws which secure it
(fig 24).
1
figure 24
6. Slide the speed adjusting handle to the
right (fig. 25a) and remove the loose belt by
cutting it or any remaining belt pieces if
the belt has already broken (fig. 25b).
If cutting the belt be careful of the
tensioning pulley and arm as they are
spring loaded and could cause injury when
the belt is cut.
figure 25a
figure 25b
7. Slip the new auger drive belt into the
compartment from the bottom of the
snowblower placing it around the bottom
of the auger drive pulley and slipping it
around the front pulley on the engine.
Ensure the belt is positioned between the
bottom belt guard and the bottom of the
auger drive pulley. You may need to remove
the bolt holding the lower belt guard in
place to properly seat the belt into the
pulley, replace the belt guard and bolt after
installing the belt into the pulley
(fig. 26a/b).
figure 26a
