CERTIFIED 060-3732-6, Instruction Manual, Page: 6 / 52

model no. 060-3732-6 | contact us 1-844-428-7277
6
SAFETY INFORMATION
16. Use only attachments and accessories
approved by the manufacturer of
snowblower (such as wheel weights,
counterweights, cabs, etc.).
17. Never operate the snowblower without
good visibility or light. Always be sure of
your footing, and keep a firm hold on the
handles. Walk; never run.
18. Take all possible precautions when leaving
the machine unattended. Disconnect the
power take-off and stop the engine.
19. Keep all nuts, bolts and screws tight to
be sure the equipment is in safe working
condition;
20. Replace worn or damaged parts for safety;
Use only genuine replacement parts and
accessories.
21. This snowblower is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities,
or lack of experience and knowledge,
unless they have been given supervision or
instruction concerning use of the appliance
by a person responsible for their safety.
22. Be careful while working on the machine or
clearing a blockage in the auger or impeller
to ensure that fingers and hands do not
become crushed or cut.
23. Do not touch hot engine components like
the muffler, muffler guard or engine block
during operation of the snowblower as they
will cause burns.
CLEARING A CLOGGED DISCHARGE CHUTE
Hand contact with the rotating impeller inside
the discharge chute is the most common cause
of injury associated with snowblowers. Never
use your hand to clean out the discharge chute.
To clear the chute:
1. SHUT THE ENGINE OFF!
2. Wait 10 seconds to be sure the impeller
blades have stopped rotating.
3. Always use a clean-out tool. DO NOT use
your hands.
MAINTENANCE AND STORAGE
1. Check shear bolts, engine mounted bolts,
etc., at frequent intervals for proper
tightness to sure the equipment is in safe,
working condition.
2. Never store the machine with fuel in the
fuel tank inside a building where ignition
sources are present such as hot water
heaters, space heaters, clothes dryers or
any open flame sources. Allow the engine to
cool before storing in any enclosure.
3. Always refer to owner’s guide instructions
for important details if the snowblower is
to be stored for an extended period.
4. Maintain or replace safety and instructions
labels, as necessary.
5. Run the snowblower for one minute to clear
out packed snow and ice to prevent freeze-
up during storage.