Certa PowerPlus CT20VNLSGNA, User Manual

Page: 4 / 16

Battery Tool Use, Charging and Care
•
This power tool must only be used with a Certa PowerPlus 20V battery pack and
charger.
•
Ensure the switch is in the off position before inserting a battery pack.
•
Do not open the battery pack.
•
Ensure battery packs are stored away from direct sunlight and other sources of
heat.
•
Do not short-circuit the battery.
•
Under abusive conditions, battery acid may be ejected from the battery; avoid
contact. If contact accidentally occurs, flush with water. If acid contacts eyes, flush
them with clean water for at least 10 minutes, then seek immediate medical
attention. Battery acid may cause irritation or burns.
•
While charging, ensure the charger cord is located so that it will not be stepped on,
tripped over, or otherwise subjected to damage or stress.
•
If the tool, charger cord or plug shows any sign of damage. Cease use immediately
and contact help.Kogan.com for support.
•
Follow the guidelines set by your local environmental authorities when recycling
and disposing of batteries.
•
Always have your power tool serviced by a qualified repair person using only
identical replacement parts. This will ensure that the safety of the power tool is
maintained.
Staple Nail Gun Safety
•
This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction concerning use of the
appliance by a person responsible for their safety.
•
Always assume that the tool contains fasteners. Careless handling of the tool can
result in unexpected firing of fasteners and personal injury.
•
Do not point the tool towards yourself or anyone nearby. Unexpected triggering will
discharge the fastener causing an injury.
•
Do not press trigger unless the tool is placed firmly against the worksurface. If the
tool is not in contact with the worksurface, the fastener may be deflected away
from your target.
•
Disconnect the tool from the power source when the fastener jams in the tool.
•
Do not use this tool for fastening electrical cables. It is not designed for electric
cable installation and may damage the insulation of electric cables thereby
causing electric shock or fire hazards.
•
Always use both hands to operate the tool. Your secondary hand should be used to
press the back of the tool firmly down onto the surface to be fastened.