Certa CTPTDCSAWA, User Manual, Page: 29 / 40

Changing the V-belt
• Loosen bolts (1) and remove belt cover (2).
•
Move the V-belt pulley into the position shown.
•
Insert the Allen key into the hole (3) to block
the V-belt pulley (5).
• Note
: Make sure that the V-belt
pulley remains blocked.
•
Use the combination tool to turn the
nut (4) about one turn counter-
clockwise.
•
Use the combination tool to turn the
eccentric (6) forcefully counter-
clockwise to the position shown.
•
Remove the old V-belt (7) or belt
fragments.
• Clean out the interior with a brush.
Insert a new V-belt:
Use the combination tool to turn the eccentric (6)
forcefully clockwise to its original position (V-belt is now
tight), tighten the nut (4).
Remove Allen key from the hole (3).
Put the belt cover (2) on and tighten the bolts (1).
Note: The V-belt is highly elastic, so it is not necessary to
retighten it.
A worn V-belt cause the cut-off disc turns at the lowest idle
speed. In this case, the V-belt must be replaced!
Cleaning the protection hood
Over time, the inside of the protective hood can become caked with material residue
(especially Iran wet cutting) which if allowed to accumulate can hinder the free rotation of
me cutting disc. For this reason, the hood must be cleaned out from time to time. Take off
the cutting wheel with spring washer and remove the accumulated material from inside me
hood with a strip of wood or similar implement.
Clean the shaft and all removed parts.