Ceriatone Dizzy 30, User Manual, Page: 8 / 16

8
AC MAINS IEC cable inlet – plug a suitable IEC power cable into this inlet to power your amplifier
MAINS FUSE
3A slow-blow fuse for countries using 120VAC power, 2A slow-blow fuse in countries using 240VAC. This is
used to protect your amplifier from voltage spikes or excessive current draw. Replace only when necessary.
SPEAKER PHASE reverses the phase output of the amplifier. Generally, use your DZ30 in the NORMAL position. This is
most helpful when combining other amps with the Dizzy 30. If you notice your amps sound thin and hollow when running them
together, they are probably out of phase. In this scenario, try the REVERSE setting.
NOTE – only change the position of the SPEAKER PHASE switch when your amplifier is in STANDBY or OFF!
LOUDSPEAKERS
¼ ” speaker cable jacks. Use a ¼ ” speaker cable to connect your speaker cabinet to the amplifier using
these jacks. If you use one speaker cabinet, it does not matter which jack is used. If you want to run two cabinets in parallel,
connect the second cabinet to the amplifier using the other jack.
NOTE – never turn your amplifier to OPERATE mode without connecting the amplifier to a speaker cabinet or suitable dummy
load! Failing to do so may damage your amplifier!
POWER two-way toggle allows you to halve the output power of the Dizzy 30. This switch effectively disconnects two of the
EL84s, and then reconfigures the bias point of the two remaining EL84s for optimum tone. In HI mode, the amplifier runs all
four EL84s for 30W Class A output power. In the LO position, output power is about 15W Class A. Each setting provides
unique tonal and response characteristics, so experiment!
NOTE – only change the position of the POWER (HI / LO) switch when your amplifier is in STANDBY or OFF!
NOTE – an EL84 must be plugged in ALL power tube sockets at ALL times, regardless of the POWER (HI / LO) setting!