Ceragon FibeAir IP-20 All-Outdoor Series, User Manual

Page: 491 / 825

User Guide for FibeAir® IP-20 All-Outdoor Products, CeraOS 10.5
Page 491 of 825
Ceragon Proprietary and Confidential
To enable the second radio carrier on both units using the CLI, enter the following
commands in root view:
root> platform if-manager set interface-type radio slot 2
port 2 admin up
root> platform management protection copy-to-mate
14.6.5 Viewing the Configuration of the Standby unit (CLI)
You can view the settings of the standby unit any time.
To view the settings of the standby unit, you can run show commands in the
standby unit. To do so, first enter the mate/root context, as described in
Performing CLI operations on the Standby unit (CLI) , then run the relevant show
command, and then switch back to the active unit.
14.6.6 Editing Standby Unit Settings (CLI)
Almost all settings of the standby unit are view-only. However, several settings
are editable on the Standby unit. They must be configured separately for the
Standby unit, and are not copied via copy-to-mate, nor do they trigger a
configuration mismatch in the CLI.
In the Web EMS, failure to synchronize these configuration settings causes a
configuration mismatch alarm.
The following settings must be configured separately on the standby unit:
• Setting the Unit Name. Refer to the description of
platform management
system-name set name
in Configuring Unit Parameters (CLI) .
• Disabling/enabling Radio TX-mute. Refer to the description of
rf mute set
admin
in Muting and Unmuting a Radio (CLI) .
• Clearing the Radio and RMON counters. Refer to the description of
modem
clear counters
in Displaying General Modem Status and Defective Block
PMs (CLI) .
• Setting the activation key configuration. Refer to Configuring the Activation
Key (CLI) and Activating Demo Mode (CLI) .
• Defining user accounts. Refer to Configuring User Accounts (CLI) .
• Setting synchronization settings. Refer to Configuring SyncE Regenerator (CLI) .
To configure these settings in the standby unit, first enter the mate/root context,
as described in
Performing CLI operations on the Standby unit (CLI) , then run the
relevant commands, and then switch back to the active unit.
14.6.6.1 Performing CLI operations on the Standby unit (CLI)
You can run CLI commands in the standby unit.
To run CLI commands in the standby unit:
1 Use the following command to enter view context for the standby unit:
root> switch-to mate
mate/root>
2 Enter the specific CLI command you want to run in mate/root context.