User Guide for FibeAir® IP-20 All-Outdoor Products, CeraOS 10.5
Page 523 of 825
Ceragon Proprietary and Confidential
root> platform management set-to-default
The following prompt appears:
WARNING: All database and configuration will be lost, unit will
be restart.
Are you sure? (yes/no):yes
At the prompt, type
yes
.
Note:
This does not change the unit’s IP address or FIPS configuration.
15.8
Performing a Hard (Cold) Reset (CLI)
To initiate a hard (cold) reset on the unit, enter the following command in root
view:
root> platform management chassis reset
The following prompt appears:
You are about to reset the shelf
Are you sure? :(yes/no):
Enter
yes
. The unit is reset.
15.9
Configuring Unit Parameters (CLI)
You can view and configure system information:
To configure a name for the unit, enter the following command in root view:
root> platform management system-name set name <name>
To define a location for the unit, enter the following command in root view:
root> platform management system-location set name <name>
To define a contact person for questions pertaining to the unit, enter the
following command in root view:
root> platform management system-contact set name <name>
To define the unit's latitude coordinates, enter the following command in root
view:
root> platform management system-latitude set <latitude>
To define the unit's longitude coordinates, enter the following command in root
view:
root> platform management system-longitude set <longitude>
To define the type of measurement unit you want the system to use, enter the
following command in root view:
root> platform management set unit_measure_format
<unit_measure_format>
To display the type of measurement unit used by the system, enter the following
command in root view:
root> platform management show unit_measure_format
