FibeAir® IP-10G
Installation Guide
Ceragon Proprietary and Confidential
Page 28 of 71
10.1
Establishing a Connection with the IDU
The default factory configuration of a new IP-10 IDU is:
IP Address: 192.168.1.1, IP Mask 255.255.255.0.
Active management ports: ports 6, and 7 (far right RJ45 ports), out-of band
management.
License: Basic – capacity 10Mbps, no ACM, Single Pipe (only GbE ports,
ports #1 or #3)
SW package: Basic – 6.xx.xx.
Protection: Disabled. 1+0 configuration
To establish a connection with the IDU:
1 Verify that no Ethernet traffic (cables or fibers) is connected.
2 Power
up the IDU.
3 Connect your PC or laptop to one of the IDU management ports (ports 6 or
7, far right RJ45 ports).
4 Set your PC or laptop to the following configuration:
IP Address: 192.168.1.240
IP Mask 255.255.255.0
No default gateway.
5 Verify connectivity to the IDU by pinging 192.168.1.1. If there is no
connectivity, verify IDU IP management configuration using the Command
Line Interface (CLI).
