To attach front wheel assembly:
• Hold wheel assembly upright.
•
Tilt stroller slightly back and
push wheel assembly onto
leg until it
locks
in place.
Repeat for opposite leg.
CAUTION:
Pull on wheel assemblies to check that
they are
locked
in place.
4
ASSEMBLY continued
Front Wheel Assembly
Footrest
To attach cup holder:
• Snap one end of cup holder
over stroller frame above
canopy.
• Rotate down to opposite
side and snap in place.
Cup Holder
WARNING
• To avoid burns, never put hot liquids in cup
holder.
• Avoid possible tipping, DO NOT place more
than 3 lbs. (1.4 kg) in cup holder.
To secure rear support frame for canopy:
• Rotate canopy forward until
it stops.
• Check to be sure
Rear Support Frame
is locked in place.
If
Rear Support Frame
is not locked, pull
forward until it locks.
Rear Support Frame for Canopy
Tray Shield included with some models.
To attach tray shield:
• Hook
“A” Tabs
under tray.
• Push
“B” Tabs
until they
snap onto bottom of tray.
• Push front of shield at
“C”
Tabs
until they snap onto
front of tray.
Tray Shield
A
A
B
B
C
C
To attach footrest:
• Snap footrest onto
stroller frame and
push up.
• Push footrest against legs,
then slide footrest down
until it snaps onto
Cross Tube
.
• Check to be sure tabs on
bottom of footrest are
snapped onto
Cross Tube.
Cross Tube
Rear
Support Frame
Swivel Locking Tabs
To attach swivel locking tabs:
• Pull
Bellow
away from
swivel
Post
on front leg.
• Align grooves on
Locking
Tab
with grooves on
Post
.
• Slide
Locking Tab
over
Post
until it snaps in
place.
Repeat for opposite leg.
Tray Shield
