16
Maintenance
Replace Condensate Pump
The condensate pump removes water that collects in
the reservoir.
1.
Unplug machine from power.
2.
Remove drain tube from machine.
3.
Remove the two upper screws on each side of the
machine, and the four upper screws on the back of
the machine.
4.
Remove the filter to ease lifting the upper housing.
Lift the upper housing up and forward. the sides of
the housing must be flared out to prevent interfer-
ance with the cassette.
5.
Remove the condensate hose from the hosebarb
on the inside of the upper housing.
6.
Disconnect the control panel wires from the display
board.
7.
Remove the lower back screws and lower side
screws. To access the screws behind the wheels,
remove the wheels.
8.
Turn the cord strain relief to loosen the cord
connection. Push the power cord into the cassette,
to allow the cassette to be removed.
9.
Lift the cassette out of the lower housing.
10. Disconnect pump wiring.
11. Remove and replace the pump .
Fan Replacement
The motorized impeller has internal thermal overload
protection. If defective, the complete assembly must be
replaced.
1.
Unplug machine from power.
2.
Remove drain tube from machine.
3.
Remove the two upper screws on each side of the
machine, and the four upper screws on the back of
the machine.
4.
Remove the filter to ease lifting the upper housing.
Lift the upper housing up and forward. the sides of
the housing must be flared out to prevent interfer-
ance with the cassette.
5.
Remove the condensate hose from the hosebarb
on the inside of the upper housing.
6.
Disconnect the control panel wires from the display
board.
7.
Remove the lower back screws and lower side
screws. To access the screws behind the wheels,
remove the wheels.
8.
Turn the cord strain relief to loosen the cord
connection. Push the power cord into the cassette,
to allow the cassette to be removed.
9.
Lift the cassette out of the lower housing.
10. Remove the fan.
11. Reassemble the new fan using the above
procedure in reverse.
Thermistor Replacement
The defrost thermistor is attached to the refrigerant
suction line between the accumulator and the evapo-
rator.
1.
Unplug machine from power.
2.
Remove drain tube from machine.
3.
Remove the two upper screws on each side of the
machine, and the four upper screws on the back of
the machine.
4.
Remove the filter to ease lifting the upper housing.
Lift the upper housing up and forward. the sides of
the housing must be flared out to prevent interfer-
ance with the cassette.
5.
Remove the condensate hose from the hosebarb
on the inside of the upper housing.
6.
Replace thermistor.
7.
Reassemble the dehumidifier in reverse order of
the above steps.
86356330 Crusader Dehumidifier
