6
• After each sealing process let the appliance cool down for approximately 30 seconds (with
lid left open) before starting again. Only use the designated foils, bags and containers with
the appliance to avoid damage. Ensure that the appli- ance will not suck in any liquid or
powder.
• Do not vacuum pack inflammable liquids (e.g. alcoholic beverages, sol- vents). Caused by
low pressure, large amounts of liquid will evaporate, thus building-up a hazardous explosive
mixture. Additionally, the appliance will get damaged.
• Containers used for vacuuming may not have any cracks and scratches. Thus, carefully
check all containers used with the appliance for perfect condition. Do not use any other than
the designated containers. Damaged or unsuited containers can burst under vacu- um with
splinters hurled about! Always handle containers under vacuum with special care, to avoid
bursting. Do not consume any food from a crushed container, because splinters could be in
the food, thus causing severe injuries.
• Do not leave the appliance unattended while connected to the power supply. Always unplug
the appliance, and wait until the sealing band cooled down, before moving, or cleaning, or
when the appliance is not in use. Do not grasp the appliance at the open lid or power cord for
moving the appliance.
• Always unplug and wait for the appliance to cool down, before cleaning or storing. Close the
lid to protect sealing band and gaskets for moving or storing.
• Do not use any abrasive cleaners, cleaning pads (e.g. metal scouring pads), or any corrosive
chemicals (e.g. bleach) for cleaning. Do not immerse the appliance or power cord in water or
any other liquid. Do not spill or drip any liquids on the appli- ance, or on the power cord to avoid
risk of fire and electric shock. When liquids are
spilled in the motor housing or sucked in, immediately switch OFF the appliance (STOP
button), unplug the appliance, and wait for the appliance to cool down. Thereafter, clean and
dry the appliance thoroughly. (See: Care and Cleaning)
• DO NOT place the appliance or any parts in an automatic dishwasher.
Important Safeguards for Electrical Appliances
The appliance is driven electrically. Place the appliance near a suitable wall power socket to
connect the appliance directly to a protected mains power supply with protec- tive conductor
(earth/ground) connected properly. Ensure that the voltage rating of your mains power supply
corresponds to the voltage requirements of the appliance (240 V,
60 Hz, AC, rated for at least 8 A).
The installation of a residual current operated circuit breaker (r.c.c.b.) with a maximum rated
residual operating current of 30 mA in the supplying electrical circuit is strongly recommended.
If in doubt, contact your electrician for further information.
• Do not use multiple electrical adapters. We recommend avoiding the usage of exten- sion
cords. However, if you wish to use an extension cord, ensure that the protective conductor is
connected properly.
