page 12
Features
and
Functions
3.1.7. Positive Close Mode
Positive Close Mode is intended for applications where the gate must
close fully against the gate end post for security reasons – such as
ensuring proper contact of a switch on the gate that feeds power to an
electric fence.
This feature operates only during the last few millimetres when the gate
closes.
It is recommended that a rubber strip be fixed to the front
edge of the gate to reduce the noise when the gate closes
against the end post.
To enable/disable the Positive Close Mode feature, please refer to the
section, 'Customising the Features and Functions' on page 16.
3.1.8. Speed Profiles
There’s no substitute for speed!
The
D2 Turbo
can be set to run in either a High Speed Mode (default)
which is approximately 24 metres per minute, or a Low Speed Mode
which is approximately 16 metres per minute.
High speeds offer a greater level of convenience and security, while
slower speeds ensure increased levels of safety at the gate.
To change the Speed Profile, please refer to the section, 'Customising
the eatures and unctions' on page
F
F
16.
3.1.9. Anti-crushing Sensitivity
The
D2 Turbo
incorporates a sensitive electronic anti-crushing
technology that responds in the event that a person or vehicle obstructs
your gate.
FIGURE 14.
Using this technology, the
typical response for an opening
gate is to immediately stop and
retract a short distance, while a
closing gate will stop and fully
re-open.
Collision Sensing can be set to
either High Sensitivity or Low
Sensitivity. Generally High
Sensitivity should be used, but
in instances where the gate runs
very poorly Low Sensitivity can
be selected.
