Centron Technologies MS930A, Service Manual

Page: 23 / 54

4 - 3
switch is set at DISABLE position, the sealing head unit remains in disabled
condition and will not be enabled even if an enable command is given.
Note 3 - Another way to reset system mode to local is turning system power switch
off and then on again, as power-on default mode is local mode.
b. Status Code List to indicate system operation;
Code Occurrence
$M,1
½
When system mode is changed to remote command mode
$M,0
½
When system mode is returned to local mode
$A,0
½
When #1 sealing head unit is disabled
$A,1 ½ When #1 sealing head unit is enabled
$A,2
½
When #1 sealing head unit has made incomplete sealing
$B,0
½
When #2 sealing head unit is disabled
$B,1 ½ When #2 sealing head unit is enabled
$B,2
½
When #2 sealing head unit has made incomplete sealing
$C,0
½
When #3 sealing head unit is disabled
$C,1
½
When #3 sealing head unit is enabled
$C,2
½
When #3 sealing head unit has made incomplete sealing
$D,0
½
When #4 sealing head unit is disabled
$D,1
½
When #4 sealing head unit is enabled
$D,2
½
When #4 sealing head unit has made incomplete sealing
$E,0
½
When #5 sealing head unit is disabled
$E,1
½
When #5 sealing head unit is enabled
$E,2 ½ When #5 sealing head unit has made incomplete sealing
$F,0
½
When #6 sealing head unit is disabled
$F,1
½
When #6 sealing head unit is enabled
$F,2 ½ When #6 sealing head unit has made incomplete sealing
$G,0
½
When #7 sealing head unit is disabled
$G,1
½
When #7 sealing head unit is enabled
$G,2
½
When #7 sealing head unit has made incomplete sealing
$S,1
½
When sealing starts
$S,0
½
When sealing ends
$R,1
½
When tubing is loaded in #1 head, so system is ready to start sealing
$R,0
½
When tubing is removed from # 1 sealing head unit
Note 1 - At the moment when the power switch is turned on, the status codes
$A,1
½
through $E,1
½
are given once.
Note 2 - The control command $S,1
½
works only after the status code $R,1
½
has
been received.