17
4. INSTALLATION
1. Inspecting the Equipment
Inspect the UPS upon receipt. If the UPS has been damaged during
shipment, keep the box and packing material for the carrier. Notify
the carrier and dealer immediately.
2. Placement
This UPS should be installed indoors with adequate airflow and free of
contamination. Locate it in a clean and indoor environment, free from
moisture, flammable liquids, and direct sunlight. Maintain a minimum
clearance of 4 inches (100mm); an ambient temperature range must be
0°C to 40°C (32°F to 104°F), and operating humidity range must be 20%
to 80% relative humidity (non-condensing).
CAUTION:
The long term uses at ambient temperature in higher than 25
°
C
which should reduce battery life. In addition, place the UPS unit away from
the monitor at least 20cm to avoid interference.
3. Charging
This UPS is shipped from the factory with its internal battery fully charged;
however, some charge may be lost during shipping. The battery should be
recharged prior to use. Plug the UPS into an appropriate power supply
and allow the UPS to charge at least 4 hours.
4. Load Connection
Connect one load-related device to each of the power receptacles supplied
at the rear of the UPS.
5. Modem/Phoneline Connection
Plug incoming telephone line into the “In” socket at the back of the UPS.
Use on telephone line cable and plug one end of the telephone line cable to
the “Out” socket at the back of the UPS. Plug the other end to the modem
input socket.
6. DC Start Function
DC Start Function enables UPS to be started up when AC utility power is
not available and battery is full charged. Just simply press the On/Off switch
to turn on the UPS.
