CDS COOLED Z6 USER GUIDE
•
This camera is a high precision device. Please do not drop and avoid any physical impact against
camera.
•
If you drop the camera in water, wipe off any water droplets from the camera with a dry cloth and
)
•
Do not leave the camera under the direct sunlight. High temperature can damage the camera.
•
Do not disassemble the camera.
•
Do not touch Parallelism Alignment Screws (3 pieces of M4 headless screws) on the beneath of
FRM72.
•
If the Parallelism Alignment Screws were adjusted by
personnel not authorized by CentralDS, the warranty will be
voided.
•
Please use a dust blower to remove dusts on the filter.
•
Do not disassemble the filter. If the airtight sealing is
damaged, dew can form inside the camera.
•
If the camera is disassembled by personnel not
authorized by CentralDS, the warranty will be
voided.
•
This camera is not waterproof. Do not leave the
camera attached to a telescope with [ cooling
system off ] for long time. Dew can form on the
surface of the camera and this can damage the
camera.**
•
If condensation forms on the camera, do not use the camera.
•
If the camera is suddenly brought in from the cold into a warm room, condensation may form on the
camera and internal parts. To prevent condensation, first put the camera in a sealed plastic bag and
let it adjust to the warmer temperature before taking it out of the bag.
•
Store the camera in a sealed container with desiccants (i.e. Silica gel) or cool, dry, well ventilated
location.
•
Image sensor dust – CentralDS tests each camera with test exposures to check the image sensor is
dust free before shipping. However about 2 – 4 % of the customer reported dusts on the image
sensor. If you see marks on your image due to the dusts on the image sensor, please contact
CentralDS for servicing. Do not disassemble the camera to clean the dusts.
•
Caution with the cooling system activated – the TEC cooling system for the image sensor is designed
to emit substantial amounts of heat to outside. This does not cause any problem on the camera
operation but a minor burn can be caused if skin is contacted with the cooling system for extended
period time.
PAGE /
CENTRALDS
5 11
