Page 11
SKU 97053
For technical questions, please call 1-800-444-3353.
AFTER uSE,
4.
clean external surfaces of the tool with a clean, moist cloth.
CAuTION!
5.
All maintenance, service, and repairs not mentioned in this manual
must only be performed by a qualified service technician.
TROuBLESHOOTINg
Problem
Possible Causes
Possible Solutions
Sander will not start.
No compressed air supply.
1.
Insufficient pressure on the Valve
2.
Lever.
Air pressure too low.
3.
Regulator (or tool) set too low
4.
Connect Sander to a compressed
1.
air supply.
Press harder on Valve Lever.
2.
Set air compressor regulator to 90
3.
PSI.
Adjust regulator setting.
4.
Sand Paper Disc not
orbiting, or orbiting
slowly.
Air pressure too low.
1.
Insufficient compressed air supply.
2.
Regulator Set adjusted too low.
3.
Leaks in Air Hose.
4.
Squeeze harder on the Valve Lever.
1.
Set air compressor regulator to 90
2.
PSI.
Adjust Regulator Set for a higher
3.
orbital speed.
Check Air Hose for leaks.
4.
Water flow low or non-
extistent.
Water Flow Control improperly set.
1.
Clogged Strainer.
2.
No water in supply tank.
3.
Adjust Water Flow Control for
1.
increased water flow.
Remove Strainer and clean.
2.
Fill supply tank.
3.
Sander does not
remove residue from
the workpiece, even
after repeated brief
attempts.
Sand Paper Disc to fine.
1.
Using wrong tool for the job at
2.
hand.
Use a more course Sand Paper
1.
Disk.
Do not continue sanding to avoid
2.
damaging workpiece surface. Use
another method to remove residue.
