SKU 97187 For technical questions, please call 1-800-444-3353.
Page 3
not in use and before connecting to this tool. Do not carry any tool with your finger on the
trigger, whether it is connected or not.
13.
Stay alert
. Watch what you are doing, use common sense. Do not operate any tool when you
are tired.
14.
Take caution as some woods contain preservatives such as copper chromium arsenate
(CCA) which can be toxic
. When cutting these materials extra care should be taken to avoid
inhalation and minimize skin contact.
15.
Check for damaged parts
. Before using any tool, any part that appears damaged should be
carefully checked to determine that it will operate properly and perform its intended function.
Check for alignment and binding of moving parts; any broken parts; and any other condition
that may affect proper operation. Any part that is damaged should be properly repaired or
replaced by a qualified technician. Do not use the tool if the trigger does not operate properly.
16.
Guard against electric shock
. Prevent body contact with grounded surfaces such as pipes,
radiators, ranges, and refrigerator enclosures.
17.
Replacement parts and accessories
. When servicing, use only identical replacement parts.
Use of any other parts will void the warranty. Only use accessories intended for use with this
tool. All accessories used must be rated 18,000 RPM or greater. Before each use, inspect
the accessory for damage or excess wear. Never use a damage or worn out accessory.
18.
Do not operate tool if under the influence of alcohol or drugs
. Read warning labels on
prescriptions to determine if your judgment or reflexes are impaired while taking drugs. If there
is any doubt, do not operate the tool.
19.
Use proper size and type extension cord
. If an extension cord is required for the compressor,
it must be of the proper size and type to supply the correct current to the tool without heating
up. Otherwise, the extension cord could melt and catch fire, or cause electrical damage to the
tool.
20.
Maintenance
. For your safety, service and maintenance should be performed regularly by a
qualified technician.
21.
Use clean, dry, regulated, compressed air at 90 PSI.
Do not exceed the recommended
90 PSI. Never use oxygen, carbon dioxide, combustible gases, or any other bottled gas as
a power source for this tool.
22. This tool has no safety shield.
DO NOT USE GRINDING DISCS, GRINDING WhEELS OR
CUT-OFF WhEELS WITh ThIS TOOL.
Note
: Performance of the compressor powering this tool (if powered by line voltage) may vary
depending on variations in local line voltage. Extension cord usage may also affect compressor
performance.
WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other con-
struction activities, contain chemicals known [to the State of California] to cause cancer,
birth defects or other reproductive harm. Some examples of these chemicals are:
*Lead from lead-based paints
*Crystalline silica from bricks and cement or other masonry products
*Arsenic and chromium from chemically treated lumber
Your risk from these exposures varies, depending on how often you do this type of work.
To reduce your exposure to these chemicals: work in a well ventilated area, and work with
approved safety equipment, such as those dust masks that are specially designed to filter
out microscopic particles. (California health & Safety Code 25249.5, et seq.)
Warning: The warnings, cautions, and instructions discussed in this instruction manual
REV 01/06;
REV 03/06
