Page 10
SKU 92918
For technical questions, please call 1-800-444-3353.
Inspection, Maintenance, and Cleaning
1.
Inspect the Nailer frequently and lubricate periodically with Pneumatic tool oil, then
wipe dry. Do not use detergent oil or additives as these lubricants will cause
accelerated wear to the internal seals.
2.
Inspect the air supply filter, if present, before each use and clean or replace as
necessary. Dirt and water in the air supply filter are major causes of pneumatic tool
wear. Use a filter/oiler for better performance and longer tool life. The filter must
have adequate flow capacity for the specific application.
3.
Store the unit in a clean and dry location.
4.
All maintenance, service, or repairs not listed in this manual are only to be
attempted only by a qualified technician
.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS MANUAL AS A
REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR MAKES ANY REPRESENTATION
OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE
PRODUCT OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE
MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS
REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS AND NOT BY
THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE
ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION
OF REPLACEMENT PARTS THERETO.
Anytime
any maintenance or repairs are done, FIRST:
1.
Disconnect the Nailer from the air hose.
2.
Empty the Nail Canister (100) completely.
3.
Attempt to fire the Nailer into a piece of scrap wood to ensure that it is
disconnected and is incapable of firing any nails.
4.
Rotate the Trigger Lock (28) to its locked position as shown on page 6.
