Page 3
For technical questions, please call 1-888-866-5797.
Item 62518
ASSEMBLY INSTRUCTIONS
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document
including all text under subheadings therein before set up or use of this product.
WARNING! TO PREVENT SERIOUS INJURY:
The
excessive weight of the Brake and Stand requires two
people to assist in the assembly and installation.
1. Place the Legs (29) on top of the Feet (28), taking
care to line up the two holes in the Legs with the
middle two holes in the Feet, as shown in Figure A.
29
Figure A
2. Assemble with Bolt (24), Washers (25 & 26),
and Nut (27). Tighten.
3. Lay the Metal Brake on the floor.
4. Place the Legs (29) against the mounting
plates of the Frame (19).
5. Assemble with Bolt (20), Washers (21 & 22),
and Nut (23) as shown in Figure B. Tighten.
Frame (19)
Nut (23) and
Washers
(21 & 22)
Bolt (20)
Leg (29)
Mounting
Plate
Frame (19)
Figure B
6. Stand the Brake upright.
7. Position the Brake in the intended mounting
place. Draw guide marks through the 1/2 inch
holes in the Feet (28) onto the floor.
CAUTION!
Before drilling mounting
holes, verify installation surface has no
hidden utility lines or water pipes.
8. Drill four mounting holes into the floor and
secure the Brake with four bolts*, lock washers,
and nuts (not supplied). *For concrete floors,
use expansion anchor bolts. For wooden
floors, use lag bolts. Use metal shims (not
included) to keep the brake even and level.
