Page 8
SKU 98178
for technical questions, please call 1-800-444-3353.
Spring between the Pin and the Bolt
at the base of the Pump.
Insert the Foot Pedal (18) into the
3.
Bracket that is part of the Ram As-
sembly and secure it with Bolt (16).
Insert the T-Handle (13) into the
4.
socket on the Brace Frame (12). Fix
in place using the Locking Pin (14).
Before first use
Pour 5 drops of good quality pneu-
matic oil lubricant into the Air Supply
Inlet of the Control Valve (24). Con-
nect the air supply and operate for 3
seconds to distribute the lubricant.
purging air from the hydraulic system:
For Manual Operation
1.
:
Press and hold the Release Pedal
(19) then pump the Foot Pedal (18)
15 to 20 times.
For Air Operation
2.
:
Connect the Air Supply Inlet of the
Control Valve (24) to the air supply
hose. Fully press the Release Pedal
(19), then turn on the Control Valve
(24) and let the Pump work for 30
seconds to eliminate any air in the
hydraulic system.
Test the Lift without a load by rais-
3.
ing and lowering it. Lower it slowly
by pressing the Release Pedal (19)
slowly. If the lift operates properly you
have completed this process. If the
Lift does raise or lower smoothly and
controllably, repeat the purging pro-
cess.
Adding hydraulic fluid to the Air Ram:
Remove the Oil Plug (30a) by gently
1.
lifting it out using a flat-head screw
driver.
Fill new hydraulic fluid through the
2.
hole, replace the Oil Plug (30a).
Purge air from the hydraulic system.
3.
See Instructions above.
rev 08j
