Page 12
SKU 96907
For technical questions, please call 1-800-444-3353.
operAting instructions
read the entire iMportAnt sAFetY inForMAtion section at the
beginning of this manual including all text under subheadings therein
before set up or use of this product.
Work piece set up
The Log Splitter can accommodate logs up to 2” long and with no more than a
12” diameter. The maximum diameter applies to most soft to medium types of
woods. Maximum diameter of hardwoods may vary depending on density of the
wood.
general operating instructions
note!
Your Warranty is VOID if the Engine’s crankcase is not properly filled with oil
before each use. Before each use, check the oil level. Do not run the Engine
with low or no engine oil. Running the Engine with no or low engine oil WILL
permanently damage the Engine. Read the manufacturer owner’s manual
thoroughly before starting this engine or using this product.
this product requires engine oil, hydraulic oil, and fuel to be added before
starting. Attempting to start the engine without oil will ruin the engine and void
the warranty. Before starting the engine, refer to the engine owners manual for
additional engine maintenance information.
Choose the 4-way splitter or the regular splitter and secure the splitter in place
with the Clevice Pin (74) and the Hair Pin Clip (41).
Check oil, gas and hydraulic fluid levels, and fill as necessary. Start the engine,
see manufacturer’s manual for directions.
Place a log on the Log Lift (1). Push the RIGHT control lever forward to engage
the Log Lift and move the log into cutting position. Do not place the logs directly
on the Rail Assembly, it is more safe and efficient to use the Log Lift.
See Figure E, next page.
When the Log is in place on the Rail Assembly, pull the lever back and allow the
Log Lift to return to the original position.
1.
1.
2.
3.
4.
