TO PREVENT SERIOUS
INJURY:
Do not adjust or tamper with
any control or component in a
way not specifically explained
within this manual. Improper
adjustment can result in
tool failure or other serious
hazards.
Note:
This Air Hydraulic Foot Pump is
designed to operate pneumatically.
It is an ideal power source for
various body, frame and alignment
applications. It can be used with
different ram kits, shop presses
and hydraulic pullers (not included)
that operate up to 10,000 PSI. It is
equipped with a factory set Safety
Valve to prevent sudden hydraulic
failure.
Note:
Check the oil level and purge
air from system before use. The
Reservoir (72) should be full but after
shipping it may need to be topped off.
Check the oil in the pump reservoir
prior to use. Place Pump on flat
and horizontal surface. Wipe top of
cylinder with clean, dry rag. Remove
the Fill Plug (77) and add the fluid
being careful not to spill. Replace
the Fill Plug and wipe up any spilled
hydraulic fluid. Periodically check the
fluid level.
FOR BEST OPERATION:
Before
use, unscrew the Breather Valve.
After use, shut the Breather Valve.
Work Piece and Work Area Set Up
1.
Designate a work area that is clean
and well-lit. The work area must not
allow access by children or pets to
prevent injury and distraction.
2.
Route the air hose along a safe
route to reach the work area without
creating a tripping hazard or exposing
the air hose to possible damage.
The air hose must be long enough
to reach the work area with enough
extra length to allow free movement
while working.
Pneumatic Tool Operation
1.
Push down momentarily on Foot
Pedal (37) and release it. The Air
Valve (12) should be raised in order
to operate. (Feel underneath the Foot
Pedal to make sure Valve is raised.)
2.
Attach the air hose from your
compressor to the Air Nipple (1).
3.
As pressure may be present, verify
that the system is not pressurized
before hydraulic hoses are connected
or disconnected. Verify this by
pressing Release Bar (43) with hand
to release any internal hydraulic
pressure. Remove the Protective
Plug (84) from the Adapter (85),
DWWDFK\RXUK\GUDXOLFKRVHZLWKDƎ
NPT end to the hose Connector (68)
directly.
Release Bar (43)
Foot Pedal (37)
Breather
Valve (79)
Bleeding Plate (41)
Base Plate (80)
Air Cylinder (15)
Page 8
Item 58047
For technical questions, please call 1-888-866-5797.
