6.
Grip tool as lightly as possible (while
still keeping safe control of it). Let
the tool do the work.
7.
To reduce vibration, maintain tool as
explained in this manual. If abnormal
vibration occurs, stop immediately.
SAVE THESE
INSTRUCTIONS.
Specifications
Air Pressure Range
110-120 PSI
Maximum Air Pressure
120 PSI
Maximum Hydraulic
Pressure
10,000 PSI
Air Inlet
Ǝ137
Oil Capacity
23 oz.
Air Consumption
7 CFM @ 110-120 PSI
INITIAL TOOL SET UP/
ASSEMBLY
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
Note:
For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
• This air tool may be shipped with a
protective plug covering the air inlet.
Remove this plug before set up.
Air Supply
TO PREVENT
EXPLOSION:
Use only clean, dry, regulated,
compressed air to power this
tool. Do not use oxygen,
carbon dioxide, combustible
gases, or any other bottled
gas as a power source for this
tool.
Adapter
Pump
1.
Incorporate an in-line oiler, shut-off
valve, hose, regulator with pressure
gauge, and filter for best service, as
shown in the diagram above.
An in-
line shutoff valve is an important
safety device because it controls
the air supply even if the air hose
is ruptured.
Note:
If an automatic oiler system is not
used, add a few drops of Pneumatic
Tool Oil to the airline connection
before operation. Add a few more
drops after each hour of continual
use.
2.
Attach an air hose (not included) to
the compressor’s air outlet. Attach
the Air Nipple (1) to the air inlet and
tighten it.
Page 6
Item 58047
For technical questions, please call 1-888-866-5797.
