11
11
ZEPHIRO 600 SPARK User Manual
Eng
240Vac - 50/60 Hz.
FUSE HOLDER
- In case you need to replace the fuse, make sure that the appliance
is switched off, disconnect the input power plug, and unscrew the fuse holder cover
shown above with a Phillips screwdriver.
CAUTION: Replace the fuse ONLY with one of the same type indicated in the sec-
(T6.3A/250V - 5x20 mm). A lower value fuse
would blow immediately after the first power on; a higher value would not act
as a fuse in case of anomalous current absorption or short circuit.
WARNING: Always connect the product to a protected circuit (with circuit break-
er). Make sure the machine has an appropriate electrical ground to avoid the
risk of electric shock or fire.
WARNING: Never connect the ZEPHIRO 600 SPARK to a rheostat (variable
resistor) or dimmer circuit, even if the rheostat or dimmer channel serves only
as a 0 to 100 % switch.
4.2. AC Cable
Connect the device to the mains with the supplied power cable. In case of loss or
replacement of the cable, refer to the following table which shows the correspon-
dence of the internal wires:
Cable (EU)
Pin
International
Brown
Live
L
Blue
Neutral
N
Yellow/Green
Earth
The earth must to be connected! Pay attention to the safety! Before taking into
operation for the first time, the installation has to be approved by an expert.
4.3. Dmx Connection
OFF
ON
T6.3A-250V
MENU
DOWN
UP
ENTER
DMX Address 1
592
READY
DMX
FAULT
HEAT
DMX IN
DMX OUT
POWER IN
POWER OUT
DMX INPUT
- Male 3-pin a XLR socket for connection to a DMX control device
