Page 12
For technical questions, please call 1-888-866-5797.
Item 62142
2) Erase Codes
CAUTION: Do not clear any DTCs before
the vehicle has been repaired and the
system has been checked completely by
a qualified technician.
As long as there is a fault
condition, the DTCs will continue
to set and turn on the MIL.
1. From
Diagnostic Menu
, select
Erase Codes
, then press
ENTER.
2. Choose whether or not to erase codes.
Erase Codes
Erase trouble codes!
Are you sure?
NO
YES
Figure N
3. When DTCs have been erased, the
following message will appear.
Erase Codes
Erase done!
Figure O
Note:
Erasing codes will reset the
Monitors to incomplete status. A
Drive Cycle will need to be completed
before performing an I/M Readiness test.
Clearing the error code will not
repair the car. Repair the car,
then clear the error code.
3) View Freeze Frame Data
View the vehicle’s operating conditions when a DTC is stored.
Note:
Not all vehicles return the same data, results
may vary from the examples given herein.
1. From
Diagnostic Menu
,
select
View Freeze Frame
,
then press
ENTER.
Note;
If more than one Control
Module is detected, each Module
must be viewed separately.
2. Select a Module, then press
ENTER.
Control Module
1/4
►
$7E8
$7EB
$7EA
Exit
Figure P
3. View data.
View Freeze Frame
1/4
DTCRFRZF
P2270
FUELSYS1
OL
FUELSYS2 N/A
LOAD_PCT (%) 0.0
Figure Q
4. Repeat for other Module(s).
5. When finished, select
Exit,
then press
ENTER.
Note:
If necessary, have a qualified
technician Interpret the data.
Brought to You by www.snapwhole.com
Brought to You by www.snapwhole.com
