25
8.2) Adjusting the height of the manual arm
The
SA-RDS
support arm can be adjusted to
met the cutting requirements based on the rail
dimensions and to allow the operator to adopt
a comfortable working position according to his
height.
There are 3 positions available;
normally the
most suitable position is the one with knobs (8)
positioned centrally
; to choose another position,
extract knobs (8) and move them into the upper
or lower slot.
Align knobs (8) in the same position to
avoid a cut which is not perfectly straight and
perpendicular to the rail.
2
1
2
2
2
1
1
8
8
The
SA-RDS
manual support arm can be
overturned from one side to the other
without needing to be removed from the
rail, to allow a comfortable and precise re-
sumption of cutting.
To carry out this operation, it is suffi
cient
to grasp it at point (A), rotate it by 180°
and move it so that it rests
on the opposite side; the re-
ference (8) has to rest on the
clamp (6).
Before mounting the
rail saw on the arm, check
that lever (7) is correctly
inserted.
8
6
A
7
8.1) Attaching the arm to the rail
Place the arm on the rail, the fi xed clamp is the same to that of the AA-RDS arm and follow the
procedure described in § 6.1.
8.3) Overturning the SA-RDS manual support arm
Overturning the arm must be carried out without the rail saw.
WARNING - Hand crushing hazard