- 4 -
Stop engine as soon as the Watercraft is on the Permaport, do not allow engine to
run while out of the water. Do not start the engine while the watercraft is on the
Permaport. Refer to Watercraft owner’s manual for further details.
Mounting Hardware
Permaport Xpress is designed to be mounted at the front. Out of preference side
mounting is possible but is not optimal
The standard hardware is suitable for both side and front mounting the Permaport to both
fixed and floating docks. In the case of extremely rough water or unusual conditions there
may be additional or alternative parts required.
It is advisable that this dock be installed by a professional dock builder. Failure to mount
the dock in accordance with the manufacturer’s instructions will invalidate the warranty.
Tools required
The Permaport has been designed to be installed with the minimum amount
of assembly and requiring only basic tools.
Note: It is essential that any electrical tools used outdoors be protected by adequate GFCI
protection, we recommend that only hand or Battery operated tools be used in close proximity to
water
3/4” Wrench or Long Reach Socket and ratchet drive (Preferred)
Drill and 9/16”
Drill Bit
Wrench
or Socket and Ratchet Drive
For a fixed dock installation the vertical
support poles need to be driven into the
lake bed, it is recommended that at least
a manual fence post driver be utilized for
this purpose.
Maintenance
The only maintenance that is required is the periodic greasing of the Roller Axles. A
spray on dry lubricant is recommended for this purpose. (available from most Hardware