Celestica A2210, User Manual, Page: 36 / 76

U S E R ’ S M A N U A L
6.1 Replacing the Signal Interface Board
The signal interface board can be removed by lifting it straight out. The fit between
the pins on signal interface board and the two sockets on the motherboard is tight.
Rocking the signal interface board back and forth while pulling helps to loosen it
from the motherboard to give the user’s hands more room.
6.2 Replacing the Server Management Board
To replace the server management board, follow these steps:
1.
Remove the video card from the system. The video card is held to the
back of the chassis by a screw that fits into a screw lock. Remove the
screw as shown in Figure 13.
Figure 13 - Removing the Video Card
2.
When the screw and screw lock are removed, the video card can be
lifted out. Rocking the video card back and forth while pulling helps to
loosen it.
3.
Remove the two screws that hold the server management board in place.
The server management board can then be taken off the motherboard.
4. When replacing the video card, be sure to reinstall the screw that
secures the card into the correct round hole (not a hexagonal air hole) on
the rear panel, as shown in Figure 14.
6-2