ISSUE 4.0
CEECO
Communication Equipment & Engineering Company
PROPRIETARY
7
PROGRAMMING CONTINUED…
EXAMPLE:
Enter #00 0106091005
Phone will be set as follows:
DIGIT 1 .. CALL RESTRICTIONS IN EFFECT
DIGIT 2 .. INCOMING CALLS ALLOWED
DIGIT 3 .. ALWAYS 0
DIGIT 4 .. 6 MINUTE TIME OUT
DIGIT 5 .. ALWAYS 0
DIGIT 6 .. ADA LED ACTIVATED
DIGIT 7 .. ALWAYS 1
DIGIT 8 .. NO PBX/ACCESS NUMBER
DIGIT 9 .. ALWAYS 0
DIGIT
10
.250ms
WINK
3.7
If it is necessary for the telephone to
automatically dial a PBX or other
access number
when the “CALL” button is pressed,
enter #18 followed
by the desired number.
Otherwise proceed to section 3.8.
Example: entering
# 1 8
9 will cause the telephone to automatically dial
the number “9”, when the phone is in operation and the call button is
pressed.
3.8
LOCATION #71-#89:
(
CALL RESTRICTIONS
)
If it is necessary for the phone to implement call restrictions, enter the
numbers the telephone is “allowed” to call, as described in this section.
Otherwise, proceed to the next section. Remember that Digit 1 in section
3.6 must have been set to “0” in order to utilize the call restriction
function. If this was not done, simply repeat section 3.6 only and return to
this section. Programming the telephone with the numbers or calling
patterns it is allowed to call blocks all other numbers or patterns. The
allowed number(s) can range from 1 to 11 digits. There are twenty (20)
memory locations available (#71-#89). Simply
enter
the intended
memory location
,
followed by the desired/allowed calling pattern.
Please refer to the example on the following page.
