ISSUE 4.0
CEECO
Communication Equipment & Engineering Company
PROPRIETARY
12
6.0 INSTALLATION NOTES AND ASSEMBLY INSTRUCTIONS
6.1
Using a 301-037 security tool (sold separately), loosen and remove the
security screw.
6.2
The security tool is for a standard 5/32" button head screw generally used
on the framework of the phone booths.
6.3
Separate the cover assembly from the back plate assembly by pulling the
bottom forward and pushing up.
6.4
The back plate assembly is designed to be mounted on any flat vertical
surface. Four mounting holes are provided.
6.5
Run the inside station wire (tip & ring) through the back plate assembly
and terminate onto the terminal block on the back plate, as depicted on the
following page.
6.6
The use of a gas tube station protector is recommended. The station
ground should not exceed 50 ohms.
6.7
Plug together the line cord wires (red & green) from the telephone
assembly and the backplate, by matching the marked surfaces of the
connectors. (refer to diagram on next page). Dress the lines/cables away
from the security screw.
6.8
Install the cover assembly by placing the two tabs into the two
corresponding slots and secure the cover assembly by tightening the
security screw.
*****WARNING*****
A.
Never install telephone wiring during a lightning storm.
B.
Never install telephone jacks in wet locations unless the
jack is specifically designed for wet locations.
C. Never touch uninsulated telephone wires or terminals unless
the telephone line has been disconnected at the network
interface.
D.
Use caution when installing or modifying telephone lines.
