ISSUE 4.0
CEECO
Communication Equipment & Engineering Company
PROPRIETARY
11
PROGRAMMING CONTINUED…
3.9
When programming is finished,
hang up
the telephone by pressing the
"CALL & HANGUP” button. Return the two plastic
mini-jumpers
to the
"OFF"
or outermost position, as depicted in the diagram on the last
page of this manual. The phone is now ready for installation/use. For
installation instructions, please refer to section 6.0.
4.0 OPERATION
To make a call, press the "CALL" button located on the front of the phone and
wait for dial tone. The RED LED (if provided) will light at this time. When dial
tone is received the transmitter is muted and the phone waits for numbers to be
dialed
.
The user may utilize the keypad to dial numbers in accordance with any
programmed call restrictions or speed dial numbers. While the call is ringing, the
LED flashes red and green.
When the call is answered, the LED turns green
(after a maximum of four seconds) and a normal speakerphone conversation is
allowed.
After the call is complete, press the button again. The LED (if provided) goes out
and the call is terminated. If user does not press the "CALL" button when he or
she is finished using the phone, then the phone will hang up after detecting dial
tone or when the telephone automatically disconnects as programmed.
If Digit 1 of Location #00 is "0" then call restrictions are in effect. The numbers
that may be dialed are restricted to the numbers entered into Location #70-#89. If
the number dialed is not in the Location #70-#89, then the phone gives three tones
and drops the line.
If Digit 1 of Location #00 is set to "1", then there are no restrictions and any
number may be dialed.
5.0 RECOMMENDED TOOLS AND TEST EQUIPMENT
Volt/Ohm Meter
5/16" Nut driver
3/8" Nut Driver
Security Tool, CEECO Part Number 301-037
Flat Blade Screw Driver
DTMF Test Set
