ISSUE 4.0
CEECO
Communication Equipment & Engineering Company
PROPRIETARY
7
4.0 TESTING/OPERATION
4.1
With the phone connected to a working phone line or a DTMF test set, lift
the handset. The telephone will wait for dial tone. When dial tone is
detected any number programmed as the first auto dial number (memory
location #19) will be dialed. The handset transmitter should be muted
(off) until dialing is complete. If the intended number does not dial out,
repeat sections 3.3, 3.5, and 3.8 only. If this does not solve the problem,
refer to section 10.2 please.
4.2
If there is a second number to auto dial (memory location #20), the phone
will either wait for the return of dial tone or wait the appropriate time
(depending on the programming selected under Location #00 Digit 2) and
dial that second number. Remember that Digit 1, under Location #00
must be set to “1” for Location #20 to be enabled. If the second number
does not dial out, repeat sections 3.3, 3.5, 3.6, 3.7 and 3.8. If this does not
solve the problem, please refer to section 10.2.
4.3
Normal phone operation should follow. Have the called party hang up.
Wait for the central office equipment to time out and return dial tone.
Shortly after dial tone is received, three tones should be heard. The phone
will open the line and remain in this condition until the handset is placed
on hook. The handset transmitter and receiver will be disabled during this
period.
4.4
Attempt to "hookswitch dial" by tapping quickly on the hookswitch. The
telephone should hang up, seize the telephone line and dial the
programmed auto dial number(s), when dial tone is received again.
5.0 RECOMMENDED TOOLS AND TEST EQUIPMENT
Volt
Meter
1/4" Nut Driver
Flat Blade Screw Driver
Security Tool 301-037