Issue 4.0
CEECO
Communication Equipment & Engineering Company
PROPRIETARY
8
*****WARNING*****
•
Never install telephone wiring during a lightning storm.
•
Never install telephone jacks in wet locations unless the jack is
specifically designed for wet locations.
•
Never touch uninsulated telephone wires or terminals unless the
telephone line has been disconnected at the network interface.
•
Use caution when installing or modifying telephone lines.
6.0 INSTALLATION NOTES AND ASSEMBLY INSTRUCTIONS
6.1
In the case of the WPP and HOB models, use a 301-064 security tool (sold
separately), and remove the security screws.
6.2
The security tool is for a standard 5/32" button head screw generally used
on the framework of the phone booths.
6.3
Separate the panel from the housing, if applicable.
6.4
Install the housing in the intended location as desired. Mounting hardware
is not included. The housings are designed to be mounted on a flat vertical
surface. Mounting holes are provided on the back of the housings. In the
case of the HOB model, a suitably sized and placed hole may have to be
drilled in the housing to enter the telephone line into the housing. If
installing the SSP-311-D-M-IVC in an interior flush mount situation, skip
this section and proceed to the next.
6.5
Run the inside station wire through the mounting box and terminate the
Tip and Ring wires to the green and red wires of the RJ11C terminal
block, located inside the box. See the over-voltage protection diagram for
details.
6.6
The use of a gas tube station protector is recommended. The station
ground should not exceed 50 ohms.
6.7
Plug the modular line cord from the panel assembly into the RJ11C
terminal block.
6.8
Dress the line cable away from the mounting holes before installing the
panel or securing the panel to the housing with the security screws.
6.9
The telephone is now ready for use.