18
Gable trim (resawn face out)
Fascia (resawn face out)
(Detailed diagrams on following pages)
2x3 roof rafter
1x4 fascia
½x3½ soffit
Cedar bevel siding
2x3 top plate
2x3 wall header
2x3 wall stud
B84DD
Trim Board Installation
Shown here is a cross-section diagram showing how the soffits and fascia would appear after they have
been applied.
All trim is minor bundled for easy identification.
1.
ALL TRIM BOARDS SHOULD BE APPLIED WITH THE ROUGH (OR WHAT IS NORMALLY REFERRED
2.
TO AS THE RESAWN FACE) FACE EXPOSED. As you will note the cedar plywood face of the shed is also
a resawn texture. This is done to allow the cedar fibre to better accept the stain. so to better protect your
3.
Corner trim (resawn face out)
Soffit (smooth both sides)
1.
2.
3.
4.
trim pieces they should also have the resawn exposed.
IT IS ALSO RECOMMENDED THAT A GOOD LATEX CAULK BE APPLIED TO THE SEAMS BETWEEN WALL
PANELS. THIS HELPS TO KEEP ANY WATER OUT THAT MAY SOAK IN UNDER THE TRIM BOARDS.
4.
Here is the order they should be applied,
Depending on the choice of the door location there may be some trimming of the trim boards required.
Altering trim boards if door is on the 4 ft [1219mm] narrow side of the high wide side of the shed.
5.
1 - 1 x 2 x 88" (P-1289G) trim board needs to be cut to 1 - 80 ½" (P-1208G) and 1 - 10 1/2" pieces. The
P-1208G trim will be used as a trim board on the wide low side of the shed. The 10 1/2" will be used on the
gable panel above the door (refer to future steps for in trim details B & C.)
Altering trim boards if door is located on the wide high side of the shed.
This trim board cutting is in addition to the noted cut required.
1 - 1 x 3 ¼" x 89½" (P-13C89G) trim board needs to be cut to 1 - 79 ¼" (P-13C79C) and 1 - 10 1/2" pieces. The
P-13C79C trim will be used as a corner trim on the narrow low wall. The 10 1/2" piece will be used on the high
wall gable (refer to a future step in trim detail C.).
½x3½ skirting
Summary of Contents for Bayside B84DD
Page 1: ...B84DD ...
