12
Fig. 6 - Mounting Bracket
Clearances (inches)
Attaching Mounting Bracket To Wall
Note:
Wall anchors, mounting screws, and
spacers are in hardware package. The
hardware package is provided with heater.
Attaching to Wall Stud Method
For attaching mounting bracket to wall studs:
1. Drill holes at marked locations using
9/64-inch drill bit.
2. Place mounting bracket onto wall. Line up
last hole on each end of bracket with holes
drilled in wall.
3. Insert mounting screws through bracket
and into wall studs.
4. Tighten screws until mounting bracket is
firmly fastened to wall studs.
Item # 0051064
(Model # MD100TBF)
Item # 0051118
(Model # MD200TBF)
Item # 0051186
(Model # MD300TBF)
Marking Screw Locations
1. Tape mounting bracket to wall where heater
will be located. Make sure mounting bracket
is level.
WARNING:
Maintain minimum clearances
shown in Fig. 3. If you can, provide greater
clearances from floor and joining wall.
2. Mark screw locations on wall (see Fig. 6).
Note:
Mark only last hole on each end of
mounting bracket. Insert mounting
screws through these holes only.
3. Remove tape and mounting bracket
from wall.
Only Insert Mounting
Screws Through Last
Hole On Each End
A
dj
oi
ni
ng
W
al
l
Floor
Min.
7 11/16 in.
16 17/32 in.
16 7/8 in.
Min.
Only Insert Mounting
Screws Through Last
Hole On Each End
Floor
A
dj
oi
ni
ng
W
al
l
Min.
11 1/8 in.
17 5/16 in.
16 7/8 in.
Min.
Min
8 3/4 in.
12 3/16 in.
14 1/4 in.
Min.
Only insert mounting
screws through last
hole on each end.
FLOOR
Adjoining W
all
Min
7 11/16 in. 16 17/32 in.
16 7/8 in.
Min.
Only insert mounting
screws through last
hole on each end.
FLOOR
Adjoining W
all
Min
11 1/8 in.
17 5/16 in.
FLOOR
Adjoining W
all
16 7/8 in.
Min.
Only insert mounting
screws through last
hole on each end.
