60
ENGLISH
3. PRODUCT INSTALLATION
Place the device on a flat, stable and dry surface. Make sure the product does not stand on
the power cord.
Fig. 3.
Avoid direct sunlight and ensure sufficient ventilation.
Fig. 4.
Remove the cardboard box and Styrofoam packing.
Lift the washing machine and remove the base packing. Make sure the small triangle foam is
removed with the bottom one together. If not, lay the unit down with on the side surface, then
remove the small foam from the unit bottom manually.
Fig. 5.
Remove the tape securing the power supply cord and drain hose.
Remove the inlet hose from the drum.
Removing the transport bolts
The transport bolts must be removed from the backside of the device before using it.
The transport bolts will be necessary again when moving the product, so make sure they are
kept in a safe place.
In order to remove the bolts:
Fig. 6.
Loosen 4 bolts with a spanner and then remove them.
Stop the holes with transport hole plugs.
Keep the transport bolts properly for future use.
Levelling the washing machine
Warning: The lock nuts on all four feet must be screwed tightly against the housing.
Check if the legs are closely attached to the cabinet. If not, please turn them to their original
position and tighten the nuts.
Loosen the lock nut to turn the feet until it closely contacts with the floor.
Adjust the legs and lock them with a spanner, make sure the machine is steady.
Fig. 7.
Water supply hose connection
Warning: Do not kink, crush, modify or sever the water inlet hose.
For the models equipped with hot valve, connect it to a hot water tap with the hot water
supply hose. Energy consumption will decrease automatically for some programs.
Connect the inlet hose following one of the below methods:
Connection between ordinary tap and inlet hose.
Fig. 8.
IM 02317 02322 02327 02332 02319 02324 02328 02333 Lavadora Bolero DressCode_IC_YV_02210311.indd 60
IM 02317 02322 02327 02332 02319 02324 02328 02333 Lavadora Bolero DressCode_IC_YV_02210311.indd 60
11/3/21 17:24
11/3/21 17:24
