POWDER AUTOFILL
MODEL PAF-2
For Ugolini MT2UL Dispenser
UNPACKING INSTRUCTIONS
Carefully unpack the
PAF-2
unit and inspect immediately for shipping damage. Your equipment was
shipped in a carton designed to give it maximum protection in normal handling, and it was thoroughly
inspected before leaving the factory. In case of damage, contact the shipper, not Cecilware.
Water Inlet Connection:
This equipment is to be installed to comply with the applicable Federal, State, or Local Plumbing Codes
having jurisdiction. In addition, a quick disconnect water connection or enough extra coiled tubing (at
least twice the depth of the unit) so that the machine can be moved for cleaning underneath.
The PAF-2 is equipped with a ¼” Flare Water Inlet Fitting which is centrally located under the main
body.
Electrical Connection:
The PAF-2 and the Ugolini Dispenser are to be both plugged into the same, 120 VAC 60 HZ
grounded duplex outlet.
HIGHLY RECOMMENDED:
A
water shut-off valve
and
a water filter,
preferably a combination charcoal/phosphate filter, are
recommended to remove odors and inhibit lime and scale build up.
PAF-2 FEATURES:
The
PAF-2
Powder Autofill is equipped with:
1.
Solid-State Level Controls,
replenish the product in the Ugolini bowls after each serving.
2.
"Out of powder" Sensors,
located
behind
the hoppers, stops the machine from dispensing water
only, thus safeguarding the machine from icing up. When the powder level inside the hopper drops
below the sensor, the dispenser will stop and the green indicator light will go OFF.
3.
20-Second Fill Delays,
prevent false or premature fill starts due to product movement in bowls.
4.
Door Safety Switch,
stops the Auto Fill System when door is opened. To check operation with
door open, depress switch button and hold for 20 seconds before filling occurs.
5.
Speed Controls,
adjust auger output for product strength.
SET-UP INSTRUCTIONS:
After all parts have been unpacked and placed on a counter:
1. Remove the (2) panel screws from the left side, and the (2) regular screws from the right side of
the Ugolini dispenser.
2. Attach the support frame to the dispenser and secure in place by replacing the (2) thumbscrews
and the (2) regular screws in their original location.
1
