6
A. TO ADJUST PRODUCT THROW (ILL # 4)
1. Open Door Assembly and remove Steam Deflector
by pulling it forward.
2. To make adjustment use a screwdriver with 1/2 inch
wide blade. Engage product adjuster as shown below
and turn as follow.
3. Turn clockwise to increase drink strength or
counter-clockwise to reduce it.
Check drink strength after every half a turn.
If after maximum adjustment, drink taste is not as
desired proceed to adjust the water flow according to
procedure B below.
4. Re-install Steam Deflector.
B. TO ADJUST WATER FLOW RATE (ILL. # 5)
1. Remove right hand side cover of the unit.
(looking at the unit from the front)
2. Locate Flow Adjustment Key inside unit mounted
above water valve.
3. Engage Flow Adjustment Key into Flow Controller
and rotate counterclockwise to decrease
and clockwise to increase drink strength.
When making strength adjustments, do not turn
Adjustment Key more than 1/8” at a time without
checking drink strength.
4. Return Adjustment Key back into keyholder.
If after maximum adjustment, drink taste is still not
strong as desired, take auger spring out of the hopper and re-
move the product adjuster.
C. DRINK SIZE ADJUSTMENT (ILL. # 6)
(AUTOMATIC UNITS - WITH TIMER)
1. Remove right side panel.
2. Turn knob on Timer right to increase or left to decrease drink size.
The number 6 on the Timer indicates approximate drink size at a
factory setting of 1 oz./sec. flow rate.
3. Press push button and check drink size. Repeat if
necessary, until desired drink size is dispensed.
4. Replace the side panel.
Illustration No. 5 – Water Inlet Valve
Illustration No. 4 – Product
adjuster
Illustration No 6 - Timer
DRINK STRENGTH ADJUSTMENTS
NOTE: The unit has been factory preset to deliver water at 1 oz. per second
