Ceasa Kivu LCD UF HF 160, Instruction Manual

Page: 56 / 116

Press "Validation" to confirm.
Setting the time of regeneration
This option is only editable if you have chosen a type of delayed regeneration (A-01, A-03).
Press the DOWN key, so that when regeneration appears.
Change the time by pressing the "Validation" key, then adjust with the UP and DOWN keys.
Normally you will leave at 2:00 am, which is the time that is preset..
Press “Validation” to confirm.
Settings Interval backwash times F-00
Press the DOWN key. It corresponds to the "interval backwash times", the number of regenerations until the valve
make a backwash will appear on the screen. To upflow valves is not necessary to perform a backwash in each
regeneration, so this setting allows you to specify how many regenerations each make a backwash. To adjust, press
"Validation" and change with the UP / DOWN buttons until the desired value. Press "Validation" to confirm.
F - 00
is a backwash every time you make a regeneration.
F - 01 is a backwash every 2 regenerations.
F - 02 is a backwash every 3 feedbacks. And so on.
Settings Volume to be treated
At this point there are two options depending on what was selected in the "Setting the type of feedback" section
•
Settings for intelligent programming (options A-03, A-04)
Press the DOWN key, in the screen will appear
50L
. Set the value to the liters of resin we have in the bottle.
To adjust, press "MENU / SET" and change with the UP / DOWN buttons until the desired value.
Press "MENU / SET" to confirm.
Press the DOWN key, the display shows
Yd-1.2
. We have to check the hardness of the water we have on the network,
we will put the amount in millimoles.
10º French = 1 millimole 10th.
To adjust, press "MENU / SET" and change with the UP / DOWN buttons until the desired value.
Press "MENU / SET" to confirm.
Press the DOWN key, the screen will display
AL-0.65
. We make the exchange capacity, depending on the type of
resin that has put in the bottle.
Fit to 0.55.
56 NASSER - CEASA