1
Measure and mark the center lines
to determine the reader position. Drill
the fi xing screw holes (Diametre: 4MM
for the mounting plate and 6MM for the
reader). Drill the wiring access area.
2
DGLIMWLC
Insert the brass anchors in the mounting
holes, connect the cable to the terminal
block, then fasten the reader with
the DIAX
®
screws using the DIAX
®
spanner.
Make
sure
that
the
varistor is connected on the lock (refer
to page 2 «Recommendations»).
Make sure that there are no pieces missing in the mounting kit. Get the right tools
according to the installation type (Drill, screw drivers, metre tape,...) and follow the
mounting instructions of the reader.
7] MOUNTING INSTRUCTIONS
3
DGLPMWLC
Insert the plastic anchors in the mounting
holes, connect the cable to the terminal
block, Then fasten the reader with the
wooden screws Leave an area to access
the cable to make the wiring). Put the
covers on top of the reader. Make sure
that the varistor is connected on the lock
(refer to page 2 «Recommendations»).
7
cdvigroup.com
EN
DGLPMWLC - DGLIMWLC
13.56 MHZ Mifare
®
Card Readers - Wiegand Output
INSTALLATION MANUAL
8] NOTES
