17
25mm
35mm
500 x 10mm
5-10mm
500 x 10mm
5-10mm
25mm
Fig.4
Installation -
preparation
Unpacking the hob:
Take care not to lose, drop or
mishandle any parts.
Fitting position of the hob:
This appliance must be,
when
installed
, a minimum of 50mm
from any back wall and a minimum
of 55mm away from any adjacent
vertical surfaces, e.g. a tall cupboard
end panel. These dimensions are
shown in Fig. 8 on page 19. If installing
the hob in a cupboard unit, then we
recommend the use of a partition
panel.
Ventilation requirements:
This appliance must be installed
to allow air to flow freely to the air
intake and from the air outlet. An
air gap of 25mm is recommended
immediately below the hob. Failure to
allow sufficient ventilation could cause
problems with operation or damage
to the hob and constitutes incorrect
installation, which is not covered by
the product’s warranty (Figs. 4 and 5).
Fig.5
Installation above a cupboard unit (with partition
panel) - recommended ventilation
Installation above an oven unit - recommended
ventilation
