40
Notes:
•
Flexible hoses can be used where the sited ambient temperature of the hose does not
exceed 70°C. These hoses must be manufactured in accordance with BS669 part 1 and
be of the correct construction for the type of gas being used.
•
Gas hoses designed for natural gas MUST NOT be used for supplying lPG gas (lPG gas
hoses can be identified by a either a red band or stripe on the rubber outer coating of
the hose).
The hose should not be crushed or trapped or be in contact with sharp or abrasive
edges.
IMPORTANT! It is the responsibility of the gas installer to ensure that the product is fully
tested and commisioned in accordance with current regulations to ensure there are no gas
escapes.
Gas connection (figs. 36, 37, 38)
•
The gas supply must use the gas inlet pipe which is located at the left hand side at the rear
of the appliance.
•
IMPORTANT NOTE:
Before connecting the appliance to the gas mains fit the female
connector (supplied with the appliance in a separate kit) to the left inlet pipe using the fibre
washer supplied.
IMPORTANT: Check the correct positioning of the connector as per pictures and always
operate using two suitable spanners.
•
The hose should not be crushed or trapped or be in contact with sharp or abrasive edges. It
should also not be subjected to corrosion by acidic cleansing agents.
The hose should also be connected in such away that it does not touch the floor and must
hang in a natural loop between the appliance and the bayonet fitting.
•
To avoid damage to the appliance gas rail inlet pipe the fittings should be tightened using
two suitable spanners.
Fig. 36
Gas inlet pipe
Connector
Summary of Contents for GB RV 701 SS
Page 2: ...2...
Page 24: ...24 S F C T A B T S Fig 13 Fig 12 Fig 16 Fig 15 Fig 14...
Page 47: ...47...