CDA EVX110, Installation, Use And Maintenance Manual

Page: 7 / 24

7
approximately six minutes before returning to speed 3. This is not a
fault. See page 21 for more information.
- To activate the intensive function increase the speed using the
remote control until the LED indicator on the extractor turns red.
- To cancel the intensive function, press button 4 to change/lower the
speed level or press button 2 to switch the extractor off.
Extractor lights
- To switch the lights on and off, press button 5 on the remote control.
- The lights on this extractor are dimmable between 20% and 100%
intensity. To adjust the lights, first switch them on as above. Press
and hold button 5 for a maximum of approximately 5 seconds or until
the desired intensity is achieved. After approximately 5 seconds the
lights will be at 20% intensity.
Please note that the lights will be at 100% intensity each time you
switch them on.
Timer
The extractor is equipped with a timer that allows the extractor to run
for 10 minutes before switching off automatically.
- To activate the timer, set the desired speed and press button 3. The
LED indicator on the extractor body will flash to confirm the timer is
active.
- To cancel the timer, press button 3 on the remote control.
Please note that the timer can be activated when the intensive
function is on, but the intensive function will still switch to speed 3
after 6 minutes. Speed 3 will switch off after the remaining 4 minutes.