DP321 User's Manual
- 23 -
5. Slide the left sprocket unit so that its sprockets match the position of the holes in the paper
and lock the unit in place. Then slide the right sprocket unit to match the width of your paper,
but do not lock it. Move the paper support midway between the two sprocket units.
6. Make sure your paper has a clean, straight leading edge. Open the sprocket covers. Fit the
first holes of the paper over the sprocket pins and then close the sprocket covers. Slide the
right sprocket unit to remove any slack in the paper and lock it in place.
7. To separate the incoming paper from the printed paper, attach the paper guide. Hold it
horizontally and fit its notches over the printer’s mounting posts. Then slide the paper guide
toward the back of the printer until you feel it click.
8. Slide the left and edge guides to the center until it stops at the triangle shaped guide mark.
9. Make sure the printer cover is closed. Then turn on the printer. When the printer receives data,
it begins printing automatically.
When using push tractor and pull tractor at the same time
1. Turn the printer off; then remove the paper guide. Pull the paper-select lever forward to the
Figure 3-13 Insert the tractor paper into the paper slot
Figure 3-14 Adjust the position of the sprocket
Figure 3-15 Load paper in the pull tractor
Summary of Contents for DP321
Page 1: ...DP321 ...
Page 50: ......
